• Drinking Water Home

• Offices and Staff

• Training

• Publications

• Emergency Response
and Security

• Rules and Laws
• Policies

• Water System Data
Sentry - SWAP - GIS

• What's New?

• Links

• Español

• Some files on this page
may require a reader.
Download a free reader.  

• Alternate File Format
Information

• Learn more about the
Division of  Environmental
Health

Groundwater Sources Under the Direct Influence of Surface Water (GWI)
View and print this publication in Acrobat PDF format

The federal Surface Water Treatment Rule applies to all Group A public water systems (community and non-community) that use:

• Surface water sources.
• Groundwater sources under the direct influence of surface water (GWI).

Such sources are vulnerable to microbiological contamination. For most affected systems, the rule requires both filtration and disinfection to control this contamination.

The federal rule defines groundwater under the direct influence of surface water as"
"any water beneath the surface of the ground with:

1. significant occurrence of insects or other macroorganisms, algae or large-diameter pathogens such as Giardia lamblia, or
2. significant and relatively rapid shifts in water characteristics such as turbidity, temperature, conductivity, or pH which closely correlate to climatological or surface water conditions."

"Under the direct influence of surface water" means the groundwater source is located close enough to nearby surface water, such as a river or lake, to receive direct surface water recharge. Since a portion of the groundwater source's recharge is from surface water, the groundwater source is considered at risk of contamination from pathogens such as Giardia lamblia and viruses, which are not normally found in true groundwaters.

Sources most likely to be under the direct influence of surface water are:

• Infiltration galleries and Ranney wells located near surface waters.
• Poorly constructed springs.
• Shallow wells located near surface waters.

Records review. DOH conducts a records review to identify "potential" GWI sources. Potential GWI sources are defined as all infiltration galleries, Ranney wells, springs, and wells less than 50 feet deep located within 200 feet of surface water.

Determination of hydraulic connection. A water system may either conduct a hydrogeologic investigation or use the water quality monitoring (WQM) method to determine whether the potential GWI source is hydraulically connected to nearby surface water. The hydrogeologic investigation requires a licensed geologist; the water quality monitoring method does not.

The WQM method requires one year of weekly measurements of temperature and conductivity (or other parameters) at both the source and the surface water. The purveyor must arrange for statistical analysis of the data to determine if there is a correlation between source measurements and surface water measurements. The department can provide assistance and will check the validity of the analysis. If either the WQM method or a hydrogeologic investigation indicate a hydraulic connection, the source is designated as a groundwater in hydraulic connection with surface water, requiring disinfection and microscopic particulate analysis.

Microscopic particulate analysis. The water system collects a sample of source water and sends the sample to a laboratory for a microscopic particulate analysis. If certain numbers or types of surface water organisms are found in the groundwater samples, the source is designated to be under the direct influence of surface water. Such sources are classified as GWI and are subject to the Surface Water Treatment Rule.

Water systems with GWI sources must achieve at least 99.9% removal or inactivation of Giardia lamblia cysts and at least 99.99% removal or inactivation of viruses. To accomplish this, systems must do all of the following:

• Filter, unless certain source quality and site-specific conditions are met to avoid filtration.
• Disinfect.
• Be operated by qualified personnel.

Systems with GWI sources or sources identified by the department as being "potential" GWI sources have several compliance options to choose from, including:

• Modify the groundwater source to eliminate direct surface water influence.
• Develop an alternate DOH-approved source (for example, develop a protected groundwater source or purchase from a nearby approved public water system).
• Attempt to meet the source quality and site-specific criteria to remain unfiltered.
• Install filtration.

• Donna Freier, GWI Program Coordinator, (360) 236-3086.

US Environmental Protection Agency
Safe Drinking Water Hotline 1-800-426-4791

 

April 2006
DOH PUB. #331-216
 

Publications

Potential GWI Sources-Determining Hydraulic Connection Through Water Quality Monitoring (269KB PDF)

Potential GWI Sources--Microscopic Particulate Analysis (227KB PDF)

More publications are available through our on-line publication catalog

DOH Home | Division of Environmental Health| Drinking Water Home | Access Washington 
 Privacy Notice | Disclaimer/Copyright Information

Links to external resources are provided as a public service and do not imply endorsement 
by the Washington State Department of Health

 

Dept. of Health Office of Drinking Water 243 Israel Road S.E. 2nd floor Tumwater, WA 98501

Mail: P.O. Box 47822 Olympia, WA 98504-7822 (360) 236-3100

Send inquiries about DOH and its programs to the Health Consumer Assistance Office
Comments or questions regarding this Web site? Send mail to Judy J. Sides.

Last Update : 01/31/2008 02:12 PM